Wasp-barcode WDI4600 2D Product Reference Guide Manual do Utilizador descarregar pdf (Página 81)

Reading Parameters Enter/Exit Programming Mode

Product Reference Guide

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable

range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See

page 232 in “References” for detailed information on setting this feature.

$CSNFN

Select Flash ON Time Setting

To configure this feature, scan

the ENTER/EXIT PRO-

GRAMMING MODE barcode above, then the barcode at

ft followed by the digits from the Alphanumeric char-

acters in

Appendix D, Keypad representing your

desired character(s). End by scanning the ENTER/EXIT

bar

code again.

Make a mistake? Scan the CANCEL barcode to abort and

not sa

ve the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

10 = Flash is ON for 1 Second

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable

range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See

page 233 in “References” for detailed information on setting this feature.

$CSNFF

Select Flash OFF Time Setting

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE barcode above, then the barcode at

ft followed by the digits from the Alphanumeric char-

acters in

Appendix D, Keypad representing your

desired character(s). End by scanning the ENTER/EXIT

bar

code again.

Make a mistake? Scan the CANCEL barcode to abort and

not sa

ve the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

06 = Flash is OFF for 600ms

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 283 284

Comentários a estes Manuais

Sem comentários

Wasp-barcode WDI4600 2D Product Reference Guide Manual do Utilizador Página 81

Comentários a estes Manuais

Manuais e produtos relacionados com Scanners Wasp-barcode WDI4600 2D Product Reference Guide