Wasp-barcode Inventory Control Manual do Utilizador descarregar pdf (Página 351)

100

101

InventoryControl Printable Help

19.16 WDT2200 - Auditing Inventory

Audit allows you to count the Quantity of one or more Items in your inventory when in Audit Mode.

Before you can conduct an audit using the mobile device, you must download a new database created

while InventoryControl is in audit mode. For more information on turning on the audit mode on the PC,

please refer to the topic Auditing Your Inventory

. For more information on creating the database,

please refer to the topic WDT2200 - Creating the PDT Database

Notes:

 Audits can also be done at the PC.

 Make sure the PDT's date and time are set correctly before performing inventory transactions.

 If Source and/or Destination sites are not specified during on the database you sent to the PDT,

the following message will be displayed the first time you attempt to perform an inventory

transaction on the PDT:

Please use the Site

Config function to

Select Source and

Destination Sites.

ESC=Exit

Press the Escape key to return to the Main Menu, then select the 6 key to go to the Site Config

function. For more information on configuring sites on the PDT, please refer to the topic,

WDT2200 - Configuring Sites

Topics discussed in this section:

Auditing Inventory

Looping on Serial Number

Looping on Location

Looping on Item Number

Looping on Track Bys (Other than Serial Number)

Auditing Inventory:

1. The Audit function can be accessed by selecting the 1 key on the PDT Main Menu.

2. Press the Enter

key after supplying an Item # or press the ESC key to return to the Main

336

1 2 ... 346 347 348 349 350 351 352 353 354 355 356 ... 517 518

Comentários a estes Manuais

Sem comentários

Wasp-barcode Inventory Control Manual do Utilizador Página 351

Comentários a estes Manuais